ASTM D3410 PDF

ASTM D is a testing standard designed to measure the compressive properties of polymer matrix composite materials reinforced by high-modulus fibers. ASTM D Testing Fixture. This method defines the compression properties in the plane of composite materials with polymer matrix reinforced with high. This standard is issued under the fixed designation D /D M; the number 1 This specification is under the jurisdiction of ASTM Committee D30 on.

Author: Yozshutaxe Tojakora
Country: Singapore
Language: English (Spanish)
Genre: Automotive
Published (Last): 23 May 2008
Pages: 196
PDF File Size: 4.36 Mb
ePub File Size: 3.45 Mb
ISBN: 199-2-73109-774-7
Downloads: 86550
Price: Free* [*Free Regsitration Required]
Uploader: Vudoktilar

The other three spacer bars are at the lower center of the photo. Auditing Consulting Sourcing Training. Need help or have a question? Evaluating how your products and services adtm and exceed quality, safety, sustainability and performance standards. What is Third Party Certification and Accreditation for the food industry?

Inspection Validating the specifications, value and safety of your e3410 materials, products and assets. The composite material forms are limited to continuous-fiber or discontinuous-fiber reinforced composites for which the elastic properties are specially orthotropic with respect to the test direction.

ASTM D3410 Shear Compression Fixture | GD3410

The four black strips are standard size, tabbed test specimens. Historical Version s – view previous versions of standard. Formally confirming that your products and services meet all trusted x3410 and internal standards.

  GALATTA MAGAZINE EPUB DOWNLOAD

The lower block normally rests freely on the base of the testing machine. Make sure the load reading is zero before starting the test. The specimen is compressed to failure.

This test procedure introduces the compressive force into the specimen through shear at grip interfaces.

ASTM D Polymer Matrix Composite Shear Load Testing – ADMET

Properties, in the test direction, that may be obtained from this test method include: Certification Formally confirming that your products and services meet all r3410 external and internal standards. Wyoming Test Fixtures Inc.

It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. One set of adtm spacers is installed in the fixture blocks. Alignment rods in linear bearings are used, rather than an external alignment sleeve as in the Celanese Compression test fixture.

Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

Place the specimen in the fixture by centering it between the grip interfaces. Make sure that the entire grip length contacts the grip faces asym the fixture is closed. Send us a request Need help or have a question? The recommended width can be 12 mm 0. Specimens should have a uniform rectangular cross section, mm to mm 5.

  GEOMETRIA DE CALVACHE PDF

The approximate thickness ranges are assuming aastm wedges are flush with the blocks when at the lower end of each range, and protruding a maximum of 0. This minimizes frictional binding between the fixture halves.

The other two sets are shown at the lower left. That is, each set of spacers provides a tabbed specimen thickness range of about 0. We’re happy to help! Apply the force at a constant strain rate until failure. Global Reach Intertek is the industry leader with over 43, people in 1, locations in over countries. Factors that influence the compressive response and should therefore be reported include the following: The test utilizes ast standard universal testing machine and a specially-designed fixture with wedge grip interfaces as described in the specification.